Thermal Fluid System Application Data Sheet

FOR JACKETED VESSELS

Please Fill out the information below, or Contact:
Customer Service
Email: customerservice@heat-inc.com
Phone: (412) 446-1177

A. Customer Information

*Required
Company Name:
Company Address:
 
*Contact Name:
*Email Address:
*Phone: Fax:
B. Process Equipment Parameters
User Equipment Description (e.g. jacketed blender, dryer, extruder, etc.):
Material of Construction:
External surface area of user vessel: sq. ft.
Type of insulation: , Thickness: in.
Weight of user vessel: lbs.
Volume of user vessel jacket: gallons
Pressure rating of user vessel jacket: psig ASME Non-ASME (select one)
Temperature rating of user vessel jacket: °F
Pressure drop through user vessel jacket: @ gpm
Size of user vessel jacket connections: Inlet: in, Outlet:
C. Product specifications:(Complete for each material)
#1 Material name:
  Specific Heat: BTU/lb-°F
  Volume of Material: gal, Density of material: lb/ft3 or
  Weight of Material: lbs (if continuous operation, use lb/hr)
#2 Material name:
  Specific Heat: BTU/lb-°F
  Volume of Material: gal, Density of material: lb/ft3 or
  Weight of Material: lbs (if continuous operation, use lb/hr)
D. Process Parameters:
Operation: Batch (e.g. tanks of vessels) Continuous
Operating temperature of the user equipment: Initial: °F, Maximum °F
Heat up time required for initial start-up: hours
Is cooling required? Yes No
Cooling required for: set point      cool down      exothermic (check one or more)
Cooling control: On/Off      Proportional
Continuous: Remove Btu/hr @ °F using (media*) from °F to °F
(* - Air, water, chilled, glycol, etc.)
E. Thermal Fluid System Parameters:
Heat Transfer Fluid:
Operating Fluid Temperature Range:
Minimum: °F, Maximum: °F, Normal Operating: °F
Heater Sizing: or Btu/hr (if known)
Flow Rate: @ ft of Head (if known)
Should the system be an    Open Skid    Sheet Metal Enclosed
F. Installation Parameters:
Distance between fluid system and process equipment:
Horizontal: ft.   Vertical : ft.
Piping between fluid system and process equipment:
Size: in.,   Schedule: , Length: ft.
Type of fluid piping insulation: Thickness:
Ambient temperature at installation site: Minimum: °F Maximum: °F
Area classification or NEMA rating:
If hazardous, is air purging acceptable? Yes    No
G. Available Utilities:
Power Available: Volts, Phase, Hz, Amps
Air: °F psig, SCFM  
Nitrogen: °F psig, SCFM  
Steam: °F psig, lb/hr  
Water: °F psig, gpm  
Thermal Oil: °F psig, gpm, Type
Other: °F psig, gpm, Type

H. Please list any requirements that may affect the design of this equipment:

  

 

 
   
 
© 2004 Heat Exchange and Transfer, Inc.
  Terms of use / Privacy statement / Site map