Tank Heating Application Data Sheet

Please Fill out the information below, or Contact:
Customer Service
Email: customerservice@heat-inc.com
Phone: (412) 446-1177


A. Customer Information

*Required
Company Name:
Company Address:
 
*Contact Name:
*Email Address:
*Phone: Fax:
B. Process Equipment Parameters
Tank Material of Construction:
Tank Interior Coatings (if any):
Tank and Thickness of Insulation (if any):
Tank Geometry: Rectangular     Cylindrical
If Rectangular, please provide: Length " , Width ", Height "
If Cylindrical, please provide: Diameter " , Height or Length: "
Is the Cylindrical tank Horizontal    Vertical
Does the tank have an open top? Yes No
Tank Capacity: gallons, Tank Weight (empty): lbs
C. Tank contents to be heated:
Fluid: , Sp Ht: BTU/lb-°F, Density: lb/ft3
Amount of Fluid to be Heated: gallons
Initial Fluid Temperature: °F, Heat up to: °F in hours
Maintain a fluid temperature of: °F
Does the tank have an Agitator OR   Re-Circulation Loop
If there is fluid re-circulation, please supply the following:
Re-circulation rate: gpm, Leaving Temp. °F , Returning Temp. °F
D. Tank Heater Data:
Heater Sizing: kW or Btu/hr (if known)
Area classification or NEMA rating:
Ambient Temperature at installation site: Min. °F, Max °F
Is the tank: Indoors     Outdoors
Are Controls Required? Yes    No
If so, what type? (check one or more)
High Limit Device: Bulb & Cap   Electronic
Temperature Controller: Bulb & Cap   Electronic
Complete Control Center
Controls are: Local Mounted    Remote Mounted (If remote, provide distance from tank: ft.)
E. Available Utilities:
Power Available : Volts, Phase, Hz, Amps

H. Please list any requirements that may affect the design of this equipment:

  

   
 
© 2004 Heat Exchange and Transfer, Inc.
  Terms of use / Privacy statement / Site map